Grab Bar Specialists
Cart

Toggler

SNAPTOGGLE® Hollow-Wall Toggle Bolts// Heavy

Ideal for Heavy Loads in Hollow Walls, Ceilings & Floors - 304 stainless steel

TOGGLER brand toggle bolts always result in the lowest possible installation cost!

TOGGLER toggle bolts pre-install without a bolt and can be installed with a screw gun. This allows one-person installations (instead of two), saving time and money. It's like having an extra pair of hands.

ANIMATED TOGGLER INSTALLATION INSTRUCTIONS

Drill 1/2" (Ø13mm) hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Minimum clearance behind wall: 1 7/8" (48mm).

Hold ends of straps between thumb and forefinger and pull toward you until channel rests flush behind wall. Slide plastic cap along straps with other hand until flange of cap is flush with wall.

Snap straps at wall by pushing side to side, snapping off straps level with flange of cap.

Drill 1/2" (Ø13mm) hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Minimum clearance behind wall: 1 7/8" (48mm).

1. Drill a 3/4" (Ø19mm) hole. Hold metal channel flat alongside plastic straps and slide channel through hole. Minimum clearance behind wall: 1-7/8" (48mm).

2. With one hand, pull plastic ring and hold straight so that metal channel rests flush behind wall, as you slide plastic cap along straps with other hand until flange of cap is flush with wall.

3. Place thumb between plastic straps. Push side to side, snapping off straps at wall.

4. Place item over flange. Insert bolt through item and tighten until flush against item, then stop.

Use machine screw or bolt to match thread in channel: BC (3/8"-16), BD (1/2"-13), BM8 (M8), and BM10 (M10).
Bolt length = item thickness + wall or ceiling thickness + 1/2" (13mm)

 

 

View Cart
0 Product(s) in cart
Total $0.00
Checkout

Credit cards